Norm,
That is correct, notice KN-xxx, obviously a KN-50 and it's later versions
would not, as it would be generically referred to as KN-xx.
KarlNet Technical Support
http://www.karlnet.com/Support/SupportKnowledgeBase.htm
614-822-5275
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Norm Young
Sent: Monday, April 05, 2004 5:04 PM
To: Karlnet Mailing List
Subject: Re: [Karlnet] KN-205 Thermal control over fan
Support, does this mean that all KN-XXX boards, including the KN-200 support
this, as long as they are running the appropriate firmware (ie; v4.44 or
higher)?
Norm
----- Original Message -----
From: "KarlNet Support" <support@karlnet.com>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Monday, April 05, 2004 10:14 AM
Subject: RE: [Karlnet] KN-205 Thermal control over fan
> All,
>
> J3 is a constant supply point. I believe what Norm is looking for is the
P3
> header on the KN-xxx. Pin 1 is ground and pin 2 is hot. This will supply
> voltage to a 5v fan, that is controlled by code to turn on when the board
> temperature reaches 45 degrees C. Once the unit has cooled to 30 degrees
C,
> it will turn off. This code was introduced in version 4.44.
>
> KarlNet Technical Support
> http://www.karlnet.com/Support/SupportKnowledgeBase.htm
> 614-822-5275
>
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Steve Loomis
> Sent: Saturday, April 03, 2004 6:05 PM
> To: Norm Young; Karlnet Mailing List
> Subject: Re: [Karlnet] KN-205 Thermal control over fan
>
>
> Digi-Key has lots of fans. I use a 24vdc ball bearing fan on my KN205's. I
> don't use the header yet, but plan to investigate using it.
>
> ----- Original Message -----
> From: "Norm Young" <lists@applegatebroadband.net>
> To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
> Sent: Friday, April 02, 2004 2:40 PM
> Subject: [Karlnet] KN-205 Thermal control over fan
>
>
> >
> > I'm burning in a KN-205 for use as a repeater, and I was under the
> > impression that J3, the fan header was going to be under some kind of
> > thermal control, as opposed to the KN-200. It looks like it isn't, and
> the
> > fan runs at the PoE raw voltage, which is unfortunate, as I'm not sure
> where
> > one finds a fan that runs at 24vdc.
> >
> > Norm
> >
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> ---
> Incoming mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.605 / Virus Database: 385 - Release Date: 3/1/2004
>
> ---
> Outgoing mail is certified Virus Free.
> Checked by AVG anti-virus system (http://www.grisoft.com).
> Version: 6.0.605 / Virus Database: 385 - Release Date: 3/1/2004
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.605 / Virus Database: 385 - Release Date: 3/1/2004
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.605 / Virus Database: 385 - Release Date: 3/1/2004
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|