No pressure, as I am not an SSB op.
OK, I downloaded the K1TTT wintelnetx thingy. I initiated the "Telnet to
COM" ini file. I adjusted mycall and stuff. I understand (through the
directions) how to send it out to the COM port on another computer (througn
null modem). How do I get NA to talk to it on the same computer?
I adjusted NA to look to COM 2 (not in use by anything else) for a TNC. I
adjusted COM on wintelnetx to send out to COM 2. I sucessfully connected to
a variety of nodes through the Telnet port and received DX spots. However,
I cannot seem to get them to go to COM 2 and into NA. I fiddled around with
several settings scenarios (through trial and error) to no avail.
At some point I also read the directions, but made little progress . . .
Help?
Don
Don Chisholm
don.chisholm@home.com
--
Submissions: na-user@contesting.com
Administrative requests: na-user-REQUEST@contesting.com
WWW: http://datom.contesting.com/
Questions: owner-na-user@contesting.com
|