At 05:07 PM 5/21/01 -0400, N4CW@aol.com wrote:
>I've been using LPT port keying with NA for years and never had a problem. I
>decided to try and incorporate the paddle capability but can't get it
>running. I enable "Keyer" in the Equipment Control Panel (ver 10.49), and
>"Paddle Sidetone" and "Curtis Type A" in the Keyer Control Panel. Once I'm on
>the logging screen, F1 calls CQ fine, and nothing happens when I connect
>"paddle common" (DB-25 pin 23) with either "dot" or "dash paddle".
>I figure there's a software switch that I'm failing to set....
>Any ideas on what I could be doing wrong?
Bert,
You need to select a paddle port in the Configuration Editor. The paddle
port selection is separate from the keying port to allow flexibility in how
you use the ports.
Dave Pruett, K8CC
DATOM Engineering
datom@contesting.com
http://www.datomonline.com QRV soon!
--
Submissions: na-user@contesting.com
Administrative requests: na-user-REQUEST@contesting.com
WWW: http://datom.contesting.com/
Questions: owner-na-user@contesting.com
|