At 08:32 PM 11/26/01 -0600, Randy Farmer wrote:
>I tried this a while back and got no responses, so I'm trying again.
>
>Is there anyone out there who has successfully controlled an Icom 746
>using any 10.xx version of NA?
Works fine with an Icom CT-17 (they aren't cheap, but they work).
In the IC-746
27 CI-V Baud Rate 9600 Auto doesn't seem to work unless the NA port
is 1200.
28 CI-V Address 56h
29 CI-V Tranceive On
30 CI-V 731 Mode Off
NA 10.53 on my laptop on COM1 works fine.
NA 10.52 on the shack P5-133 set up as below:
Config
F4 Serial Config
COM1 3F8 9600 Xcvr1 4 (won't go any faster!)
COM2 2F8 9600 None 3
COM3 3E8 9600 TNC 5 (long serial cable to the PacketCluster box)
COM4 2E8 1200 None 9
F5 Equipment Config
A/B None
Xcvr #1 IC-746
The rest are whatever I've got plugged into things on the computer!
|