Re: [NA-User] Interface problem

["Bob, N5RP" <n5rp@pdq.net>]

Now then, my answer may seem strange,
but since you can sync by pressing the ALT/F1 or ALT/F2 a couple of times,
it would seem that you do not have a problem.

here, on this end, upon start-up, even with all radio station components 
booted from cold, I do the ALT/F1 and ALT/F2, as well - not to sync 
perhaps, but to check and insure proper interface relationships.

So you and I perform the same function activities, and achieve the same 
results.

You see a problem, I do not see a problem.

I hope I was properly polite in the tone of my reply.

73,
Bob - N5RP
======================================
At 23:58 12/10/2003, Ray wrote:
> I am having a problem that occurs when I turn off my FT1000MP that is 
> interfaced to NA logging software. I keep the computer running since it is 
> my interface to Packet. Later, when I turn on the FT1000MP, the software 
> does not sync with the band & mode displayed on NA. The CAT LED does flash 
> as it should.
>
> The only way I can get the two to sync is to press the ALT/F1 or ALT/F2 
> (band up/down) a number of times, then it may sync. Pressing the band / 
> mode buttons on the radio does not do it.
>
> Is there a command, procedure or other process that will get the radio and 
> software to sync? It is more likely to be an NA problem or FT1000MP 
> problem? Anyone else have this problem.
>
> Ray,
> N6VR


_______________________________________________
NA-User mailing list
NA-User@contesting.com
http://lists.contesting.com/mailman/listinfo/na-user
NA on the web:  http://www.datomonline.com/