Bob and others,
I see we all do the same to get the radio and computer to match
bands/mode. I call it a problem, in that, my TS940S radios synced
immediately with NA whenever they were turned on and off. I installed
the PIEXX interfaces in those radios..
Still wondering the reason why it is necessary to do the Alt /F1-F2 with
Yaesu FT1000MP and not the Kenwood TS940S? I do recall using the
original Kenwood factory interfaces, they were not as reliable as the PIEXX.
Ray,
N6VR
Bob, N5RP wrote:
Now then, my answer may seem strange,
but since you can sync by pressing the ALT/F1 or ALT/F2 a couple of
times,
it would seem that you do not have a problem.
here, on this end, upon start-up, even with all radio station
components booted from cold, I do the ALT/F1 and ALT/F2, as well - not
to sync perhaps, but to check and insure proper interface relationships.
So you and I perform the same function activities, and achieve the
same results.
You see a problem, I do not see a problem.
I hope I was properly polite in the tone of my reply.
73,
Bob - N5RP
======================================
At 23:58 12/10/2003, Ray wrote:
I am having a problem that occurs when I turn off my FT1000MP that is
interfaced to NA logging software. I keep the computer running since
it is my interface to Packet. Later, when I turn on the FT1000MP, the
software does not sync with the band & mode displayed on NA. The CAT
LED does flash as it should.
The only way I can get the two to sync is to press the ALT/F1 or
ALT/F2 (band up/down) a number of times, then it may sync. Pressing
the band / mode buttons on the radio does not do it.
Is there a command, procedure or other process that will get the
radio and software to sync? It is more likely to be an NA problem or
FT1000MP problem? Anyone else have this problem.
Ray,
N6VR
_______________________________________________
NA-User mailing list
NA-User@contesting.com
http://lists.contesting.com/mailman/listinfo/na-user
NA on the web: http://www.datomonline.com/
_______________________________________________
NA-User mailing list
NA-User@contesting.com
http://lists.contesting.com/mailman/listinfo/na-user
NA on the web: http://www.datomonline.com/
|