I finally got around to buying a PIEXX interface card for my TS940, and
it is installed. Now I am trying to figure out the steps to get NA
configured and put it to work. I have been using a keying interface on
COM1. COM2 is used by a modem, although that is no longer a necessity.
LPT1 is available for the cable to the PIEXX interface, but I have not
connnected a cable yet, since it looks like an adapter will be needed
for the LPT.
I ran config just to see what the options were, and it appears that the
best choice is to select PIEXX930 (test something like that) for radio
#1 and choose LPT1 for the port. Is this correct, and what else will I
have to do, if anything?
Rob
_______________________________________________
NA-User mailing list
NA-User@contesting.com
http://lists.contesting.com/mailman/listinfo/na-user
NA on the web: http://www.datomonline.com/
|