Gee, and I thought it was just me and my flaky computer. I did notice
that changing back to 10.59 fixed that, but then lose out on the
upgrade. :(
73, Gerry K8GT
----- Original Message -----
From: M Ketchell <k5er@arrl.net>
Date: Sunday, September 2, 2007 11:44 pm
Subject: [NA-User] keyboard freq entry causes mode change
To: na-user@contesting.com
> During NAQP recently, we ran Multi-2, with two ICOM 756 Pro
> II's, and
> dos computers running NA 1063. Noticed that when using the computer
> keyboard to
> direct enter frequency on 10, 15 or 20 meters, the mode would swap
> from USB to
> LSB. A quick press of the buttom on the radio made things right.
> Then you scan
> the band for mults, hit the top and, to QSY quicker, enter the freq
> for the
> bottom of the band again and boom, radio goes to the right
> frequency, but also
> swaps back to LSB again. This only seems to happen to the three
> upper bands. If
> already in LSB or CW mode, direct entry does not force change.
> I have not tried any other templates, or other rigs. For
> the record, I
> have changed the hex address of the rig(s) to emulate a standard
> Icom 756 Pro.
> This happened on each of the two radios, both with and without the
> networkingfunction enabled.
> Any help/advice would be appreciated. Thanks in advance.
>
> 73!
> Mark, K5ER
>
>
> "Putting NORTH Louisiana on the contest map"
> _______________________________________________
> NA-User mailing list
> NA-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/na-user
> NA on the web: http://www.datomonline.com/
>
_______________________________________________
NA-User mailing list
NA-User@contesting.com
http://lists.contesting.com/mailman/listinfo/na-user
NA on the web: http://www.datomonline.com/
|