I have the same problem; however, this issue was present in version 1.365
also.... I use the 'programmable' AGC to set the AGC decay to below 80
db/s
Ron ....... NU1U
-----Original Message-----
From: orion-bounces@contesting.com [mailto:orion-bounces@contesting.com] On
Behalf Of William H. Hein
Sent: Saturday, November 15, 2003 17:55
To: orion@contesting.com
Subject: [Orion] Programmable AGC Problem
I downloaded and installed Orion firmware 1.366 earlier today while I was
getting my station ready for Charlie K1XX to use in SS. While checking the
various menu parameters afterwards I noticed that I could not set the Main
RX programmable AGC decay below 80 dB/s. I had not problem setting the Sub
RX programmable AGC to 20 dB/s (the recommended "contesting" setting per the
Orion Optimize document that Ten-Tec published last summer), but I could not
get the Main RX to go there.
Is this a bug or am I doing something wrong?
73,
Bill NT1Y
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|