Grant,
It is all relative; it doesn't have to make sense. What is slow to one may
be fast to another. All three AGC variables should have the same ranges....
Ron ........ NU1U
-----Original Message-----
From: orion-bounces@contesting.com [mailto:orion-bounces@contesting.com] On
Behalf Of Grant Youngman
Sent: Sunday, November 16, 2003 01:54
To: orion@contesting.com
Subject: RE: [Orion] Programmable AGC Problem
It helps to read the manual. See page 33.
The decay setting ranges in SLOW/MED/FAST AGC positions are
restricted to values that make sense for those AGC speeds.
Programmable AGC is settable over the entire decay rate range of 5-2000dB
second.
It wouldn't make sense to have the "slow" AGC position be settable to
80dB/second, 'cause that isn't "slow", any more than it would make sense to
have "fast" agc settable to 2000dB/second, because that's essentially "off".
So there are ranges that make sense:
Slow -- 5-20dB/second
Med -- 20-80dB/second
Fast -- 80-200dB/second
Prog -- 5-2000dB/second
Before anyone complains that they should have just made all of the AGC
settings totally variable, just remember that with absolute certaintly,
there's bound to be someone else who would have wanted it some other way.
So this way, you get both. Be happy :-)
Grant/NQ5T
> I have the same problem; however, this issue was present in
version
> 1.365
> also.... I use the 'programmable' AGC to set the AGC decay to
below
> 80 db/s
>
> Ron ....... NU1U
>
>
> -----Original Message-----
> From: orion-bounces@contesting.com
> [mailto:orion-bounces@contesting.com] On Behalf Of William H.
Hein
> Sent: Saturday, November 15, 2003 17:55 To:
orion@contesting.com
> Subject: [Orion] Programmable AGC Problem
>
> I downloaded and installed Orion firmware 1.366 earlier today
while I
> was getting my station ready for Charlie K1XX to use in SS. While
> checking the various menu parameters afterwards I noticed that I
could
> not set the Main RX programmable AGC decay below 80 dB/s. I
had not
> problem setting the Sub RX programmable AGC to 20 dB/s (the
> recommended "contesting" setting per the Orion Optimize
document that
> Ten-Tec published last summer), but I could not get the Main RX
to go
> there.
>
> Is this a bug or am I doing something wrong?
>
> 73,
> Bill NT1Y
>
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>
>
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
-------------------------------
Grant Youngman /NQ5T
http://www.globeking.com
nq5t@comcast.net < == NEW
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|