Hi Folks,
Getting ready to set-up a ground buss behind all the equipment on the
operating table. Running a six ft piece of 1/2 inch copper pipe which
is connected to the ufer ground system.
Want to ask whether 1/2 inch flat silver tinned braid strap is OK to use
to interconnect the equipment to the copper pipe. I expect the jumpers
will be from one to two feet long.
I vaguely remember reading that braid was not preferred when trying to
reduce unwanted RF currents. If my memory serves me correctly it was
stated that a piece of #16 guage wire was better than using 1/2 inch
braid.
thanks,
dave
WA3GIN
--
FAQ on WWW: http://www.contesting.com/FAQ/rfi
Submissions: rfi@contesting.com
Administrative requests: rfi-REQUEST@contesting.com
Questions: owner-rfi@contesting.com
|