RFI
[Top] [All Lists]

Re: [RFI] Low pass filter opinions

To: rfi@contesting.com
Subject: Re: [RFI] Low pass filter opinions
From: Jim Brown <jim@audiosystemsgroup.com>
Reply-to: jim@audiosystemsgroup.com
Date: Thu, 13 Jan 2011 19:17:37 -0800
List-post: <rfi@contesting.com">mailto:rfi@contesting.com>
On 1/13/2011 3:08 PM, dalej wrote:
> Would it be best for me to run a separate wire from each XLR pin 1 to the 
> nearest point on the chassis, which might require drilling holes?  Or perhaps 
> one hole drilled in the chassis at the opposite end of the PCB with another 
> wire to a stud there.  I'm not planning to sell this as it has no second hand 
> value so drilling holes is not a big deal as long as it's not in the front 
> panel.

NO!  Go back and study what I've written in earlier posts over the last 
few days.

73, Jim K9YC
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>