I could put the blocking arrestor after the HD-1480 switch and ground
it to the connex (steel shipping container) and then a non-blocking
one at the entrance to the house - grounded to the whole-house common
ground.
That would peel-off much of the lightning surge and help to defend
the receiver(s) better than only the non-blocking arrestor at the
house, would it not?
I understand that in the added device there is some small loss and
an added step of potential hardware failure (not only the device
but the extra coax jumper).
> The reason for the DC Block is that the protector device (gas tube,
> MOV, or whatever) conducts once a certain voltage is reached. By blocking
> DC, the voltage across the protector rises faster and it starts conducting
> at a much lower energy point of the discharge, keeping more energy out of
> the equipment. Offers extra protection for receivers. The situation for the
> tower mounted preamps mentioned by Frank, where the protectors pass DC, in
> the amp, the pickoff for power blocks the DC so the lightning protector does
> not need the block to achieve the same level of protection. --Mike, WV2ZOW
--
Thanks! & 73, KD4E
David Colburn http://kd4e.com
Have an http://ultrafidian.com day
I don't google I SEARCH! STARTPAGE.com
Shop Freedom-Friendly http://kd4e.com/of.html
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|