RFI
[Top] [All Lists]

Re: [RFI] ARRL to FCC...

To: "Dale J." <dj2001x@comcast.net>, dave@nk7z.net
Subject: Re: [RFI] ARRL to FCC...
From: Tom Thompson <tlthompson@qwest.net>
Date: Wed, 26 Mar 2014 12:18:32 -0600
List-post: <rfi@contesting.com">mailto:rfi@contesting.com>
Dale,

I checked with Costco and they only carry LED back lit TV sets now. In thinking about it further, I don't think making a measurement on the power cord with an RF current probe would be too definitive anyway because of the RFI coming from the other sets connected on the same circuit. It would be instructive if you could conduct some tests on your neighbor's set. Would it be possible to use a battery and quiet inverter to power the set with all other wires disconnected? You might have to connect the cable to get the screen to light. If you could do that and it eliminated the RFI then the line filters Ed suggested might work for you.

Just some thoughts.

Tom   W0IVJ

On 3/26/2014 2:23 AM, Dale J. wrote:
My next door plasma is broadband hash with various bumps along the way.  I have 
one of those bumps especially bad at 3.857, it's 20 db over 9 and sounds like a 
motor running but changing speed and sometimes stopping and starting.  The 
broadband hash is all over the 80 meter band and 40 too.  The upper bands are 
less affected. I suspect part of the noise is from a switching power supply in 
the plasma tv, that might be what that motor sounding noise is not sure though. 
 I wish it were my TV, I could then find out more how these things tick before 
permanently disabling it.  Makes it difficult on my USAF MARS net too.

Dale, k9vuj



On 25, Mar 2014, at 21:16, David Cole <dave@nk7z.net> wrote:

Imagine thousands of little lightening bolts...  Thats Plasma TV.
--
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net
for MixW support see;
http://groups.yahoo.com/neo/groups/mixw/info
for Dopplergram information see:
http://groups.yahoo.com/neo/groups/dopplergram/info
for MM-SSTV see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info


On Tue, 2014-03-25 at 18:28 -0600, Tom Thompson wrote:
Ed,

I checked out a few plasma tv sets a couple of years ago with a portable
shortwave receiver.  The RFI was coming right out of the front of the
set which made sense since that was where the discharge was occurring.

Tom   W0IVJ

On 3/25/2014 12:31 PM, Hare, Ed W1RFI wrote:

Thanks, Dale.

We can then see if the TV is still in production.  If it is no longer 
manufacturered, it may be a harmful interference complaint, not a possible 
emissions-limit violation.

The ARRL Lab would also be willing to provide a few filters to try, if your 
neighbor is willing to work with you.  Some have speculated that the noise 
comes directly from the TV, and this could be true, but I still tend to think 
in terms of noise coming out the AC mains and possibly also being radiated by 
the shield of the incoming coaxial feed line.

-----Original Message-----
From: Dale J. [mailto:dj2001x@comcast.net]
Sent: Tuesday, March 25, 2014 2:29 PM
To: Hare, Ed W1RFI
Cc: rfi@contesting.com
Subject: Re: [RFI] ARRL to FCC...

Ed

I'll see if I can get that information from my neighbor, but it will take a 
while.  I have to actually get in the house and look at the back of the TV and 
get the model number because I don't think they know for sure.  As soon as I 
get it I'll send you a email.

Tnx
73
Dale, K9VUJ


On 25, Mar 2014, at 13:04, "Hare, Ed  W1RFI" <w1rfi@arrl.org> wrote:

If the ARRL Lab can get some reports involving specific model numbers, we can 
do some testing and find out where these plasma sets stand.  I had a report in 
MD that involved two Samsung plasma TVs. One made very loud radiated noise, 
while the 2nd model, also a plasma TV, was quiet.

I need reports that involve a plasma TV operating in a neighbor's home causing 
harmful interference.  So far, most of the reports have been about the QRZ.com 
and RFI list discussions, not a specific report.

The ARRL Lab can measure conducted noise and radiated noise from devices, but 
we really need to start with actual, non-general reports.

Ed Hare, W1RFI
ARRL Lab

-----Original Message-----
From: RFI [mailto:rfi-bounces@contesting.com] On Behalf Of KD7JYK DM09
Sent: Friday, March 21, 2014 12:23 AM
To: rfi@contesting.com
Subject: Re: [RFI] ARRL to FCC...

: Now if they would recall all the damn plasma TV's out there doing the same
: thing it would really tickle my butt cheeks...but, any such action is
: goodness!

How mant times have you contacted the FCC regarding the interference to your 
licensed service?

Kurt

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi


_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>