RFI
[Top] [All Lists]

Re: [RFI] LG machines can be OK

To: jim@audiosystemsgroup.com
Subject: Re: [RFI] LG machines can be OK
From: Alex <alex@kr1st.com>
Date: Sat, 27 Jan 2018 18:31:57 -0500
List-post: <mailto:rfi@contesting.com>
OK, so you know more about this than me. I'm sure my point is not lost on 
others.

73,
--Alex KR1ST


On Jan 27, 2018, 5:11 PM, at 5:11 PM, Jim Brown <jim@audiosystemsgroup.com> 
wrote:
>On 1/27/2018 11:11 AM, Alex wrote:
>> We purchased a LG washer (model WM3270CW) and dryer (model DLE3170W) 
>> at the end of 2016 based on a Consumer Reports recommendation and 
>> searching the net for *substantiated* reports of RFI problems (we 
>> found none). 
>
>Exactly what would you consider "substantiated?"
>
>> After installation I checked with a FT-817 around the appliances and 
>> found no significant RFI from either.
>
>While we're all glad that you've found a good product that doesn't
>cause 
>you problems, I would not consider your report "substantiated." Rather,
>
>I would like to see broadband waterfalls that cover a wide swath of 
>frequency from an SDR connected to some sort of antenna close to the 
>product and its wiring. Noise generated by electronic products that are
>
>not arcing tends to concentrated in frequency. There are broad "humps" 
>of noise that repeat very 10 - 30 kHz and are unstable in frequency 
>(generated by switch-mode power supplies and motor controllers), and 
>there are steady (or pulsing) carriers (generated by microprocessor 
>clocks and their circuitry.  Noise from these products is often much 
>stronger (or absent) in different frequency ranges. The 33V power
>supply 
>that SteppIR shipped me was MONDO noisy between 17M and 10M (like 20dB 
>over S9 on 12M into the 3-el on a 120 ft tower 200 ft away!). Noise was
>
>present on lower bands, but not nearly as bad.
>
>The most likely cause of RFI in a product that has a motor is a
>variable 
>speed controller for it. Variable speed controllers are a strong and 
>well known cause of RFI. They cause RFI when the motor is running, but 
>are unlikely to do so when the machine is idling. Another likely cause 
>is a switch mode power supply for on-board electronics.
>
>73, Jim K9YC
>
>_______________________________________________
>RFI mailing list
>RFI@contesting.com
>http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
<Prev in Thread] Current Thread [Next in Thread>