On 9/13/2018 10:36 AM, Dave Van Wallaghen wrote:
So, my questions are: as the largest portion of this noise comes from
my TV plugged into the AV circuit, would running separate grounds for
my AV and shack circuits back to the panel help alleviate some of the
noise that I find on my shack circuit ground? Or do you think most of
it is being physically coupled? I would have tried this myself, but
while certainly doable, it will be a little work to make it happen.
Several thoughts on this.
First, RF noise from defective/poorly designed equipment OFTEN travels
on the green wire, so yes, separate green wires is a good thing.
Second, chokes to kill noise currents need to be tuned to the
frequency(ies) where you are bothered by the interference. While PROBING
for noise sources at lower frequencies can be effective, there's no need
to choke those frequencies unless you use your radio there.
Third, if the TV is a noise source, I would choke every cable connected
to it, starting with those that are likely to be the most effective
radiators, first the power cable and coax feeding it, then audio and
video cables if there are any.
I also read on the Polamar website about using #75 mix Clamp On cores
for use on frequency ranges down to 200 kHz. Is this something
applicable to my problem?
Only if you need to kill noise on the new 630M band, and only if you
wind a lot of turns. Simply clamping one or more of them onto cables is
unlikely to do much.
I'm surprised that you're hearing a lot of noise coming from an LCD TV.
The most likely source would be a poorly filtered switch-mode power
supply built into it. I would also look for other sources around the TV,
like switch-mode wall warts for various equipment, or built into other
equipment.
73, Jim K9YC
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|