RFI
[Top] [All Lists]

Re: [RFI] DFing intermittent connection

To: rfi@contesting.com
Subject: Re: [RFI] DFing intermittent connection
From: donovanf@erols.com
Date: Mon, 16 Aug 2021 13:32:12 -0400 (EDT)
List-post: <mailto:rfi@contesting.com>
Jim, 


Please ignore Scott's advice, it will cause tower corrosion and quickly fail 


73 
Frank 
W3LPL 

----- Original Message -----

From: "K9MA" <k9ma@sdellington.us> 
To: jimk8mr@aol.com 
Cc: rfi@contesting.com 
Sent: Monday, August 16, 2021 4:30:35 PM 
Subject: Re: [RFI] DFing intermittent connection 

Or just use the braid from some RG8 and a couple hose clamps. 



---------- 

Scott Ellington. K9MA 

--- via iPhone 

> On Aug 16, 2021, at 9:27 AM, jimk8mr--- via RFI <rfi@contesting.com> wrote: 
> 
> The kit is basically a very heavy, very flexible cable, six feet or so, with 
> lugs on both ends, and clamps with a large flat surface to attach to the mast 
> and to the tower leg. I'd think that the bottom lug could be attached to a 
> tower bolt, or some other low resistance connection to the tower. 
> It would seem to also be simple to homebrew something a bit less rugged, 
> perhaps using a piece of RG-8, shield and center conductor connected 
> together. 
> 
> 73 - Jim K8MR 
> 
> 
> 
> -----Original Message----- 
> From: EDWARDS, EDDIE J via RFI <rfi@contesting.com> 
> To: RFI List <rfi@contesting.com> 
> Sent: Mon, Aug 16, 2021 9:09 am 
> Subject: Re: [RFI] DFing intermittent connection 
> 
> Just FYi...They told me they only have the bypass kits for standard Rohn 
> towers, but not for the BX or HDBX series towers. Need to make your own for 
> other non-rohn configurations. 
> 
> 73, de ed -K0iL 
> 
> -----Original Message----- 
> From: RFI On Behalf Of jimk8mr--- via RFI 
> 
> 
> You might look into DX Engineering's Bearing Bypass Ground Kits 
> DXE-BBGK-2-25-P. 
> I installed one yesterday for K8AZ. I'm not sure if Tom had a particular 
> problem or it was just as a precaution. It easy to install, the only issue in 
> my case was that the tower had been painted, so some paint scraping was in 
> order. But much easier than replacing a thrust bearing! 
> 
> 73 - Jim K8MR 
> 
> _______________________________________________ 
> RFI mailing list 
> RFI@contesting.com 
> http://lists.contesting.com/mailman/listinfo/rfi 
> _______________________________________________ 
> RFI mailing list 
> RFI@contesting.com 
> http://lists.contesting.com/mailman/listinfo/rfi 

_______________________________________________ 
RFI mailing list 
RFI@contesting.com 
http://lists.contesting.com/mailman/listinfo/rfi 

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>