It was on, but not adjusted to zero out noise. Balance was in the middle
between both antennas. There was no attenuation set. The phase knob is at
12oclock.
The NCC2 requires adjustment every time I use it, and each adjustment is
only effective with a specific noise.
73 KC2IEB
On Mon, Aug 22, 2022 at 9:27 AM EDWARDS, EDDIE J <eedwards@oppd.com> wrote:
> Hi Chris,
>
> Just wondering if you had your DXE NCC-2 Noise Phaser turned on or off
> during your outage testing?
>
> 73, de ed -K0iL
>
> -----Original Message-----
> From: RFI On Behalf Of Christopher Wawak
>
> Hi all, I had a Generac 16KW generator installed early this year. The
> generator is specced to power my entire house load. Luckily/unluckily
> haven't had a chance to really try it out. Until today.
>
> Today, we've been without utility power for a few hours, and I noticed
> absolutely no interference to my HF radios! I didn't check VHF
> unfortunately, I wanted to take advantage of the lack of neighborhood HF
> noise!
>
> Utility power literally just came back on, and I could see the noise floor
> jump 2 s units. I'm sure a lot of this is installation, radio, and antenna
> specific, but in my case, I'm pleased.
>
> Happy to answer questions about the unit, but my verdict is, in my
> installation, it seems quiet.
>
> 73 KC2IEB Chris
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
>
> https://urldefense.com/v3/__http://lists.contesting.com/mailman/listinfo/rfi__;!!AvPafw!L_FLGVg9FyqT5BPyVNd2-Sq14bfUx8jFpexHykTSsIE7rYpxUYdzsKuDEr_E8pD7SYZjtnNU_G4lCg$
>
>
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|