Apparently error 216 has to do with not finding the comport. I confirmed
this by changing the port specified in rtty.ini for the TNC. I have a
byterunner pci card adding 4 ports for a total of 6 in the pc but running
WF1B in a dos window will not let me "see" the 4 extra ports. Com 1 and 2
are built into the machine and control the radio and the mmtty/fsk
interface. I intended to use 3 in MMTTY as the KAM emulator and 4 in WF1B as
the TNC port but I guess I'm back to square one. I see from the instructions
that this combo has been run before but it must not have used PCI cards.
Anybody have any further ideas?
73 Jamie WW3S
----- Original Message -----
From: "Jay" <jay@ieway.com>
To: "The Tolberts" <jtolbert@gremlan.org>
Cc: <rtty@contesting.com>
Sent: Wednesday, September 26, 2001 9:59 PM
Subject: Re: [RTTY] wf1b runtime error 216
> At 09:03 PM 9/26/01 -0400, The Tolberts wrote:
> >Trying to configure WF1B to run with MMTTY. ( thanks for all the help
with
> >mmtty and fsk; the problem was I had the interface built using dtr
instead
> >of txd, all is well; worked vu2 and a92ge) I have MMTTY configured using
> >TNC KAM emulation on COM3 and this works well with LOG-EQF. When I try to
> >run WF1B however I get to the config screen and then when I hit
ctrl-enter
> >to move on I get runtime error 216. Any ideas what that is?
>
> Under Pascal RTE 216 is a General Protection Fault. Probably MMTTY and
WF1B
> are occuping the
> same memory space.
>
> You might, might, try increasing files and buffers.
>
> Good luck.
>
> 73 Jay WS7I
>
> CU from Texas at W5KFT.
>
>
|