This is a multi-part message in MIME format.
------=_NextPart_000_0006_01C15269.CF290420
Content-Type: text/plain;
charset="iso-8859-1"
Content-Transfer-Encoding: 7bit
Richard, use the Internet Sprint contest module. It was set up for the
original RTTY Sprint and will do everything for the existing sprint except
score band mults. (The original sprint didn't have band mults). Don't worry
about re-scoring it yourself, just send the log to me and I will re-score
it...I have attached a "short" text file on how to set up the contest
module...
Wayne k7wm@i10net.com
----- Original Message -----
From: "Richard Zanni" <kj6ra@starband.net>
To: <writelog@contesting.com>
Sent: Thursday, October 11, 2001 5:07 AM
Subject: [WriteLog] RTTY Sprint
> I am sure it's probably obvious, but, what contest would one select to
> participate in this weekends RTTY Sprint?? I can't seem to see one listed
in
> the menu.
>
> Thought I might try this out as I have been working with the MMTTY and
would
> try out RTTY contesting for the first time.
>
> Thanks
> Rich
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
------=_NextPart_000_0006_01C15269.CF290420
Content-Type: text/plain;
name="NCJRTTYSPRINT.txt"
Content-Transfer-Encoding: quoted-printable
Content-Disposition: attachment;
filename="NCJRTTYSPRINT.txt"
Writelog does not support the NCJ RTTY SPRINT per se, but with small =
modification, the existing Internet Sprint Contest Module can be used.
Open Writelog and click on, "Select New Contest", from the contest =
module selection, click on "Internet Sprint". On the "transmit previous =
name" window that comes up, click "cancel", this will put it out of the =
way. Click on "Bands", "Setup Bands", "Clear all Bands". Then in the Low =
edge window, type 3570, hit the tab and in the High edge window, type =
3600. Uncheck all modes except the FSK box. Click "add this band". Do =
the same for 40 meters and 20 meters. (these are the only bands you will =
need). When this is done, close the Band Setup window and another window =
will come up showing you your frequencies, if they are ok, click "ok". =
Click on "Bands" again and then "Set Frequency & Mode", Uncheck all =
modes except FSK, click on 14060 which is in the window and then click =
"OK". Click on Contest, "Parameter Setup", type in the name you will be =
using in the contest and the state you will be operating from. Click =
"OK". Setup your message buffers and then click File, "Save as" and give =
the contest whatever name you want and then click "Save". Your ready to =
go.=20
All I need is the log, however you want to send it. You can even send me =
your .wl file but please send me a log. We are trying to keep the NCJ =
RTTY SPRINT alive and the only way we can is show entries.
------=_NextPart_000_0006_01C15269.CF290420--
|