> I've powerded the DigiKeyer not from FT-1000MP but from external
> power supply (about 13 V). Does make it a difference or a problem?
No, it should not make any difference or create a problem. The
reference to powering from the radio was to indicate that the
radio's aux output was fused and would have protected the radio
in the event of a failure in DigiKeyer.
73,
... Joe Subich, W4TV
microHAM America
http://www.microHAM-USA.com
http://groups.yahoo.com/group/microHAM
support@microham.com
> -----Original Message-----
> From: rtty-bounces@contesting.com
> [mailto:rtty-bounces@contesting.com] On Behalf Of Jacek Janusz
> Sent: Thursday, September 27, 2007 12:40 PM
> To: rtty@contesting.com
> Subject: Re: [RTTY] A technical question (DigiKeyer)
>
>
> Hello Joe,
>
> Thank you for the very detailed information about the DigiKeyer and
> for direct email to me from the microHAM company. Yes, it looks that
> the problem lies in the different place, probably in the transceiver.
>
> JSW> If you were powering DigiKeyer from the +13.8 V output of
> JSW> FT-1000MP (normal operation),
>
> I've powerded the DigiKeyer not from FT-1000MP but from external power
> supply (about 13 V). Does make it a difference or a problem?
>
> 73!
> Jacek.
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|