David..
I have had 2 reports of this happening and have been looking at the code to
see what would be causing it. The odd thing is the WAE code has not changed
in 3 years so I'm not sure why this would be happening now. If you were
using the MMVARI engine within N1MM I could see the problem you are having I
found a couple of major error's I created in the WAE implementation in the
MMVARI Engine. I have correct most of those and will be in the next
release...
73's Rick N2AMG
-----Original Message-----
From: rtty-bounces@contesting.com [mailto:rtty-bounces@contesting.com] On
Behalf Of David Wilburn
Sent: Monday, November 10, 2008 9:42 AM
To: RTTY Reflector
Subject: [RTTY] WAE RTTY QTC N1MM & MMTTY
I did my first QTC exchanges yesterday. Really messed the first one
up. But got the hang after that. I tried sending a QTC, but on my
display it printed out from left to right. On QTC's I had received,
there was a LF after each QTC. I went into the settings => WAE on
MMTTY, and it shows <ENTERLF> after each line.
Is it possible it is printing on my terminal linear (left to right)
but printing with the line feeds at the other end?
--
David Wilburn
NM4M
http://www.nm4m.com
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|