RTTY
[Top] [All Lists]

Re: [RTTY] Forwarded message

To: rtty@contesting.com
Subject: Re: [RTTY] Forwarded message
From: Don AA5AU <aa5au@bellsouth.net>
Date: Fri, 14 Jan 2011 22:37:27 -0800 (PST)
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
It appears the hyperlink to my RTTY SO2R article did not come out correctly.  
It 
is:

http://www.rttycontesting.com/so2r.htm

73, Don AA5AU


----- Original Message ----
From: Don AA5AU <aa5au@bellsouth.net>
To: rtty@contesting.com
Sent: Sat, January 15, 2011 12:13:23 AM
Subject: Re: [RTTY] Forwarded message

It's ironic that Dick would pose these questions when I just completed my 
column 

for the March/April issue of NCJ on RTTY SO2R operation (Part I).

Since I know Dick is a subscriber to this reflector, I will address him as well 
as the other subscribers as I believe it's important others know.

You do NOT need a DX Doubler or any other type of SO2R interface to run RTTY 
SO2R.  I have been running RTTY SO2R for nearly 20 years now with no such 
complicated interface.

RTTY SO2R is simply two RTTY stations combined with band filters, antenna 
switching and headphones to listen to both radios at the same time.  No special 
SO2R box is required unless you absolutely feel you need automated filter and 
headphone switching.  With RTTY, you certainly don't need headphone switching.  
Filters can be switched manually as I have done since day one.  Save your money 
and spend it on a good set of band filters from ICE, Dunestar pr a good set of 
stubs.

Many years ago I wrote a webpage on RTTY SO2R at 
http://www.rttycontesting.com/so2r.htm which I need to update.  It gives a lot 
of information that will help the future RTTY SO2R operator.  More information 
will be found in the 2011 March/April NCJ RTTY Contesting column and well as 
the 

2011 May/June edition which will include Part II of my SO2R column.  If you 
don't subscribe to the National Contest Journal (NCJ) and you consider yourself 
a serious contester, then you should.

Hopefully this will not spark the very blase subject of SO1R vs SO2R.  The fact 
is, if you are a serious RTTY contester and do not run SO2R, you are missing 
out 

of the unimagineable fun of being on two bands at the same time and filling all 
that void time between CQs with something as productive as CQing on another 
band 

or S&P for additional mults.  All the while, you are being busy and productive 
and having a friggin' good time.

RTTY SO2R is not for everyone.  But if you have a passion for RTTY contesting, 
get off your butt and do something other than watch TV and read your e-mail 
while you are pressing the F2 key.

Don AA5AU



----- Original Message ----
From: "Bill, W6WRT" <dezrat1242@yahoo.com>
To: rtty@contesting.com
Sent: Fri, January 14, 2011 9:31:08 PM
Subject: [RTTY] Forwarded message


Subject: DXDoubler Question
From: "DickT-W0RAA" <dickt@w0raa.com>
Date: Fri, 14 Jan 2011 14:19:16 -0700

I hope I can get some help with my question.  I have several questions
and 
it would probably be best if the  context was taken off the reflectors, 
unless you felt it could benefit other members.  If you would like to
get a 
dialogue started and help me, you can e-mail me at w0raa[at]arrl.net.

That being said, I have the following questions to ask (And probably
more):

I have a Yaesu FT-950 and a Yaesu FT-857D.  The 950 is my main radio,
and 
the 857D is a backup.

My antennas consist of a Butternut HF-9V ground mounted vertical and
soon 
(to replace a beam & tower that succumbed to 90 MPH winds) a Cushcraft
A3S 
beam on a Rohn 25G as a replacement.  I will also be putting back up a
Van 
Gordon Engineering 80 meter shortened dipole.

I would like to set up a SO2R contest setup and have been looking at the
DXDoubler as a means of doing so.  At present I have to switch one radio
out 
of service to listen on another band for activity, and that can be 
confusing, not to mention a time waster.  A DXDoubler looks like it
might be 
a solution to my needs.  Will it be a simple setup?  What cables would I
need? Etc, etc.

So, is anybody using a similar setup to mine (950, 857D, antennas, etc)
that 
can offer me some guidance on how I should proceed and not break the
bank, 
which would keep the XYL happy.  I know none of you guys have ever had
that 
problem before, so I mention it as a possible hindrance.  :)

Any help or somebody saying I just don't have enough antennas to do it
would 
be appreciated.  I live in an upscale mobile home retirement community
here 
in Colorado Springs and they tolerate beams, verticals and such.  I try
to 
stay as low key as possible even with their permission.

SO if you care to help I would be appreciative.

73 & Tnx,

Dick
W0RAA
w0raa[at]arrl.net  or  dickt[at]w0raa.com 
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>