RTTY
[Top] [All Lists]

Re: [RTTY] Signal Link USB

To: Kok Chen <chen@mac.com>, RTTY <RTTY@contesting.com>
Subject: Re: [RTTY] Signal Link USB
From: Tom Horton <k5iid@sbcglobal.net>
Date: Wed, 9 Feb 2011 19:13:23 -0800 (PST)
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
Chen and all ...
 Thanks very much. That is very helpful info.
 Hope to see you on there soon.
 Tom iid

--- On Wed, 2/9/11, Kok Chen <chen@mac.com> wrote:


From: Kok Chen <chen@mac.com>
Subject: Re: [RTTY] Signal Link USB
To: "RTTY Reflector" <RTTY@contesting.com>
Cc: "Tom Horton" <k5iid@sbcglobal.net>
Date: Wednesday, February 9, 2011, 3:04 PM



On Feb 9, 2011, at 12:32 PM, Tom Horton wrote:

> I am about to order a Signal Link USB to use with my old FT-1000MP. Just to 
> make sure, what connector do I want for hookup to the radio? 8 pin round mic 
> plug or ????

The SignaLink USB is an AFSK device.  Use the rear panel 5-pin DIN (PACKET) 
connector to bypass the voice processor.  Do not use the RTTY connector, which 
is for FSK.

Turn RF PWR to max, and adjust the RF output power you desire by using MIC GAIN 
(which will change the line input gain from the PKT connector also).  I know it 
is counter intuitive to use MIC GAIN to adjust RF output, but it is the way to 
avoid ALC from kicking in.  Adjust the MIC GAIN for the desired RF output 
power, but in all cases, make sure there is no ALC reading on the meter.  None, 
zilch, nada.

The PKT mode of the 1000MP uses LSB, so be sure to tell your sound card 
software to use LSB if you run QPSK31.  BPSK31 will work with either LSB or 
USB, so no need to worry if you don't use QPSK31.  Tell your sound card to use 
AFSK LSB (I think most of them default to LSB anyway).

There is a Menu item (6-5) in the FT-1000MP to choose the Packet tonepair.  If 
your software is using the 2125/2295 Hz pair, choose the 2110/2310 pair in Menu 
6-5 so your receive IF filters will center properly (yes, you can use narrow IF 
filter in the FT-1000MP Packet mode).  There is a typo in the operating manual 
-- it list that tonepair as 2110/3130 (yeah right, 20 Hz shift).  They also 
list the 2025/2225 pair as 2025/2125 (100 Hz shift :-) :-).

If you want to use the Packetcluster spots, be sure to also change the Packet 
frequency display menu (6-4).  If you are using the 2125/2295 Hz tone pair, 
dial in -2125 (note the minus sign, in LSB, your Mark tone is below the 
suppressed carrier) and your VFO dial will red out the RTTY mark frequency.

73
Chen, W7AY

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>