ORIGINAL MESSAGE:
On Thu, 17 Feb 2011 01:00:22 -0600, "Jeff Blaine"
<keepwalking188@yahoo.com> wrote:
>Don't bet on the "cheaper" as a given. That depends in a HUGE
>way on the quality of your junk box and the amount of time you have
>to dedicate to the project.
REPLY:
That's true. Here's my breakdown on my homebrew amp's most expensive
parts:
Two Hammond cabinets: $320
Power transformer: $400
8877: $550 (Chinese)
2x vacuum variable caps: $300 (used)
2x turns counters: $160
Bandswitch: $300
3x meters: $240
Blower, 91 CFM: $145
Total: $2415. All parts are new except the vacuum variables. If you're
a good scrounger the cost can go WAY down.
That is just for the most expensive parts. Other stuff like wire,
resistors, capacitors, nuts and bolts, etc, etc, probably added another
$400 or so. And of course, my time was free. :-)
Roughly half the cost of a new Alpha 8410, but it did take nearly a hear
to put it together. It could have been done in a month or two but I took
my time. Of course it does not have the bells and whistles that an Alpha
has, but there's less to go wrong, too. So far I haven't needed any
bells and whistles. Haven't needed any repairs either.
And it will do brick-on-the-key with the best of them, mainly because of
the oversized blower. The exhaust temp never gets over 145 degrees F,
even during a contest. I have owned three Alphas over the years and this
runs cooler than any of them. (91b, 89 and 9500)
Like I said, not for everybody, but it has the big advantage that I can
fix it myself - no expensive trips back to the manufacturer, ever.
73, Bill W6WRT
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|