Bob,
I'm running N1MM on RIGBLASTER PRO in a TS950SDX running FSK.
The Rigblaster running on a USB /serial interface.
The Com to Radio a W1GEE cable interface on a USB/serial interface.
What I believe I'm seeing/hearing is the Radio Com port interfering with
the FSK signal.
It is not constant during transmissions but rather rhythmic 4 or 5
chirps then a period of "normal" transmission with repeats every several
seconds.
It occurs if I enable the "rig interface" and TX through N1MM/Rigblaster.
It occurs when the "rig interface" is enabled, even if I simply press
the "send/receive" button on the TS950SDX.
Which is what is making me lean toward "rig control" rather then signals
from the Rigblaster.
On 04/02/2011 8:11 PM, Robert Chudek - K0RC wrote:
> Mike,
>
> Are you using FSK or AFSK? What is your interface?
>
> 73 de Bob - KØRC in MN
>
>
> On 4/2/2011 8:04 PM, Michael Haack wrote:
>> Hey all,
>>
>> While playing a bit in the EA RTTY contest earlier, I got a comment or
>> two of my signal sounding chirpy.
>>
>> A little investigation reveals that its only there when I using the "RIG
>> Control to radio"
>> The sound is that of a bird chirping. And I see output power
>> fluctuations at that same time.
>>
>> It is _NOT_ on the signal when I turn off the Rig Control. Even at Full
>> output.
>>
>> Is this a Setting issue with the Rig interface/ Polling??
>>
>> The Software: N1MM
>> The Radio: Kenwood TS950SDX
>>
>> Ideas...???
>>
>> Thanks, 73
>> MIKE, WB9B
>> _______________________________________________
>> RTTY mailing list
>> RTTY@contesting.com
>> http://lists.contesting.com/mailman/listinfo/rtty
>>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|