If you are using N1MM Logger, this resetting can be automated.
On the Digital Interface window, click Setup>Settings. On the upper left
of the Settings window, there is a column of 11 checkboxes, two of which
start with "MMTTY". Check both of those boxes. Now when you go from Run
to S&P, AFC will be turned off and vice versa. Also when going from Run
To S&P, the tones will be reset to their default values if AFC has
caused them to change.
These settings are for stations using FSK. If you are using AFSK and you
have both AFC and NET turned on, they are not needed.
A very handy feature. I wouldn't operate N1MM Logger FSK without it.
73, Bill W6WRT
On 1/6/2012 3:04 PM, KC4HW/Jim wrote:
> Thanks to WX6V for taking the time from his practices sessions to tell
> me why he was not copying me very well. It was the AFC in MMTTY
> that had move the mark tone off quite a bit when I was copying
> another stations earlier and I forgot reset it.
>
> Still got some coax to run to get the 10m/15m antenna into the remote
> switch, don't know how much I will need them, but I should be able to
> get that done tomorrow.
>
> Looking forward to being in the mix this weekend.
>
> Have Fun!
>
> Jim/KC4HW
> Ham Radio is a contact sport!
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|