RTTY
[Top] [All Lists]

[RTTY] Hi John Re: N1MM Logger+ RTTY macro question

To: john@bordertech.co.uk, rtty@contesting.com
Subject: [RTTY] Hi John Re: N1MM Logger+ RTTY macro question
From: RLVZ--- via RTTY <rtty@contesting.com>
Reply-to: RLVZ@aol.com
Date: Mon, 4 Jan 2016 13:46:08 -0500
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
 
Hi John,
 
Thank You for the reply about my F2 macro issue.
 
If I set my F2 "run" macro just as you indicated below, then  here's what I 
get when the F2 macro is sent by pressing the  Enter key: the other 
stations Callsign is sent once on the current line,  computer jumps to the next 
line, and then the Callsign is sent the 2nd time  along with the report.
 
I'm in the ESR mode, after entering the Callsign in the Callsign field, I  
press Enter, I want the computer to jump to the next line and send the 
Callsign  once along with the report.  (I do not want the Callsign sent on the  
current line as that wastes too much time)
 
Thanks,
Dick- K9OM
 
 
In a message dated 1/4/2016 12:10:50 P.M. Eastern Standard Time,  
john@bordertech.co.uk writes:

Dick,

Are you sure you are looking at the run line of the  macro? Mine reads:
F2 REPORT,{TX}{ENTER}! 599 66 66 {RX}
And it does  exactly that. New line, sends call etc.
John GW4SKA

-----Original  Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of  RLVZ--- via
RTTY
Sent: 04 January 2016 16:59
To:  rtty@contesting.com
Subject: [RTTY] N1MM Logger+ RTTY macro  question

Hi guys,

The ARRL RTTY Roundup was an excellent way to  start the 2016  contest
season!  If we worked, thanks for the  Q!

I tried asking my Logger+ question to the Logger+ reflector   but didn't get
a reply.  Hoping someone here has the answer for me:  When  using N1MM 
Logger+ and running stations, when I press the F2  key to send  the 
Logger+ exchange, the exchange goes out on the  current line, but I'd like 
this  exchange to jump
to the next blank  line as I believe it would be easier to  see.  Note: if I
edit  the F2 macro and begin  with a "ENTER" then the other stations  
Callsign
still gets sent on the  current line and the report gets sent  on the next
line.  If  I edit the F2 macro and begin with "Enter"  and "!" then his
Callsign gets sent  twice, once on the current line  and again on the second
line.  When  running, I only want to send  the other stations Callsign one 
time and
I want it  to be sent on the  next line along with the report.  It appears
that the F2  "run"  macro has a default setting that cannot be edited during
the normal   editing process.  Please advise if there is a way for me to 
edit
the  F2  "run" macro so the other stations Call is only sent once  after
jumping to  the next blank line?

Thanks!

Dick-  K9OM



_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>