Hi Dick,
I don't know if you solved this yet but here's what I have
F2 Run Exch, {TX} 599 NE NE {RX}
F5 His Call, {TX}{ENTER} !{RX}
Pay attention to the spaces, N1MM will do the F5-F2 sequence for you,
don't need the other guys call in your F2 macro. Adjust to your liking
on the spaces, I always put one in at the start of a new line and at the
end.
73,
Ron
K0IDT
On 1/4/2016 12:46 PM, RLVZ--- via RTTY wrote:
Hi guys,
The ARRL RTTY Roundup was an excellent way to start the 2016 contest
season! If we worked, thanks for the Q!
I tried asking my Logger+ question to the Logger+ reflector but didn't get
a reply. Hoping someone here has the answer for me: When using N1MM
Logger+ and running stations, when I press the F2 key to send the
Logger+ exchange, the exchange goes out on the current line, but I'd like
this exchange to jump
to the next blank line as I believe it would be easier to see. Note: if I
edit the F2 macro and begin with a "ENTER" then the other stations
Callsign
still gets sent on the current line and the report gets sent on the next
line. If I edit the F2 macro and begin with "Enter" and "!" then his
Callsign gets sent twice, once on the current line and again on the second
line. When running, I only want to send the other stations Callsign one
time and
I want it to be sent on the next line along with the report. It appears
that the F2 "run" macro has a default setting that cannot be edited during
the normal editing process. Please advise if there is a way for me to
edit
the F2 "run" macro so the other stations Call is only sent once after
jumping to the next blank line?
Thanks!
Dick- K9OM
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|