In N1MM+ whatever is in the main Di window is the TX software. The
additional RX windows are RX only. So to use 2Tone for TX in N1MM+ need to
make it the main Di window software.
73 David G3YYD
-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Dave AA6YQ
Sent: 11 November 2017 08:40
To: 'Aleksander Otulak'; rtty@contesting.com
Subject: Re: [RTTY] MMVARI and 2Tone (stand-alone?)
>>>AA6YQ comments below
-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Aleksander
Otulak
Sent: Saturday, November 11, 2017 3:31 AM
To: 'Joe Subich, W4TV'; rtty@contesting.com
Subject: Re: [RTTY] MMVARI and 2Tone (stand-alone?)
Thanks for the info. However, I am a bit confused.
In AFSK,
if one starts 2Tone within N1MM+ MMTTY interface (or WinWarbler, etc.),
which one does the transmitting 2Tone or the MMTTY, please?
>>>In WinWarbler, 2-Tone is "receive only"; it is not used for
>>>transmission. AFSK or FSK transmission can be accomplished via the
MMTTY engine, via an external modem (KAM, PK232, etc), or via an Elecraft
K3.
Once, I was told that in such a tandem 2Tone just copy the receiving part,
while MMTTY does both transmitting and an independent (from 2Tone)
receiving.
>>>That's correct for WinWarbler.
>>>WinWarbler can also display RTTY decoded from a third source in
>>>addition to 2-Tone and MMTTY: an external modem, an Elecraft K3,
or VE3NEA's GRITTY application.
73,
Dave, AA6YQ
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|