> .. however ESM in S&P-mode seems not to be operating properly.
> It seems to be sending the just received exchange rather than
> the former one as the second Enter is pressed.
Thanks - you're right! That's fixed and you can get the
updated SD.EXE (V13.10D) from www.ei5di.com/sd/sdexe.zip.
The new SD.EXE should replace whatever version you're using
now - in your SD folder.
I recommend you use the CWZERO command to set the "Serial
Padding Factor" to a value of 3. That gives extra spacing
between the characters sent - and you'll get fewer requests
for repeats. If you do get a request for a repeat, you
will have to send it manually (in S&P) mode because, once
the QSO has been logged, the "former" exchange is updated.
SD-User mailing list