> DVP question... I did get the message for call and CQ's to work ok for CQ
> and S&P. Can you program #'s or letters? I do not remember how to set
> that up.
The ability to program letters and numbers is not available.
> While running and using the Clarifier for RX it would put the program into
> S&P. I read the manual and it said that using shift keys would tune the
> clarifier. It tuned the radio...Yeasu FT-1000 issue (my guess).
The Yaesu's command set doens't let me tune the RIT very well. Sounds
like you have the AUTO S&P mode enabled if tuning the RIT is making
you go into S&P.
> Also on 40 meters, I noticed that the QSX frequency was not getting into
> the radio correctly from the spots. I did look at a few of the spots and
> noticed that they seemed to be correct. I noticed that the B VFO would be
> slightly above the A VFO.
I'll have to look at this.
> Is there an auto repeat CQ message feature?
Yes - Alt-Q.
Tree
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|