The only things which will matter for you will be transceiver OFF (must be
off), radio address, and radio type.
To set the address of a radio the command needs to come AFTER the radio type
in the LOGCFG.DAT file. I am fixing that in the next release, but for now
there is an order dependence.
RADIO ONE NAME = Icom735
RADIO ONE TYPE = IC737
RADIO ONE RECEIVER ADDRESS = 4
If it still does not work, then please send my your LOGCFG.DAT (and related
files if any STDCFG.DAT, etc).
73 es God Bless de KK1L...ron rossi(firstname.lastname@example.org) <><
Support Programmer for TRLog http://www.qth.com/tr
QTH: Jericho, Vermont
My page: http://www.qsl.net/kk1l
>>>"Akins, William" said:
> I've tried about everything I could think of: transceiver off, transceiver
> on, lengthening "icom response time out" and "poll" rates, baud rates, radio
> address, radio type, etc. etc., all to no avail.
> I seem to be able to get commands "to" the radio from TRLog, the problem is
> in reading the data back "from" the radio into TRLog when I tune the radio
> or change modes on the radio, and of course sending cw from the parallel
> port to the radio does not work either.
> Bill, W1LEE
> Trlog mailing list