Sorry about the Alt-D confusion. That had nothing to do with my testing of
the Ctrl-End, Enter operation in both 6.84 and 6.85 where it works fine for
me. I do it just like you describe and the active radio follows in both
releases.
My comment about the Alt-D commands is that when I did the first couple of
tests on 6.84 the INACTIVE radio switched frequency rather than the active
radio. Therefore, I was guessing that maybe my Alt-D commands were messed
up causing that aberration. But after that, 6.84 worked just fine doing the
operation just the way you describe. From what I can see, it is working
fine in both 6.84 and 6.85. I've been testing 6.85 the better part of the
day today.
Good Luck & CU in SS,
Ed - W0YK
> -----Original Message-----
> From: trlog-bounces@contesting.com
> [mailto:trlog-bounces@contesting.com] On Behalf Of Dale Martin
> Sent: Friday, November 03, 2006 3:18 PM
> To: 'TRLog Reflector'
> Subject: Re: [Trlog] TR685 available
>
>
> > > I haven't yet downloaded 685, but 684 Bandmap CTL-END,
> > ENTER only puts
> > > the call callsign in the callsign field, but does not move
> > the radio.
> > > I've tried it with both CTL's and on both my Omni 6's on
> different
> > > bands. No joy.
> > >
> > > Is anyone else seeing this?
> >
> > 685 works fine.
> >
> > 684 (the last release before 685 and what is still posted)
> works fine,
> > too ... except for the first few times I did the Ctrl-End,
> Enter when
> > it moved the INACTIVE radio. I could never get it to do
> that again,
> > but maybe that's what's happening to you. In my case, I
> may have the
> > Alt-D commands set wrong in LOGCFG.DAT in my 684 testing.
> >
> > In 685, I have all three Alt-D commands set to FALSE and
> all the SO2R
> > features seem to work great so far.
> >
> > 73,
> > Ed - W0YK
> >
>
> Thanks for the note, Ed. However, this wasn't and
> ALT-D-related operation
>
> The cursor was in the main callsign entry field. I simply
> did a ctl-end, scrolled down to the desired callsign, and
> pressed <ENTER>. The call appeared in the callsign entry
> field, but the radio was not taken to the callsign's bandmap
> frequency.
>
> I tried it on both radios, in CQ mode, in S&P mode, and nothing.
>
> Changing bands (Alt-v/b) works fine. As does simply typing
> the frequency into the empty callsign field. Also, pushing
> the band buttons on the radio changes radio and TR.
>
> I may go back to 6.78....this is an important feature for me
> because as QRP, I do a lot of S&P and the bandmap gets a lot of use.
>
>
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|