I have been using several versions of SIIG PCI 4-port cards with DOS 6.22
and TR-Log for several years with no problems. One gotcha I sometimes
forget when setting up a new computer is that the BIOS Plug and Play
parameter must be set to "Off" or "No". But, I doubt that is your problem
based on your report below of what DOS and TR-Log are reporting.
73,
Ed - W0YK
> -----Original Message-----
> From: trlog-bounces@contesting.com
> [mailto:trlog-bounces@contesting.com] On Behalf Of Steve London
> Sent: Tuesday, December 05, 2006 8:09 AM
> To: TR
> Subject: [Trlog] Multi-port serial port woes
>
> Has anyone been able to get TRLog to work with a PCI
> multi-port serial board that was not a Byterunner ?
>
> I have a 4-port PCI serial board, and the DOS driver from the
> manufacturer. The driver seems to be working - at least it's
> output says useful things like:
>
> Port 1:E800H, IRQ: 09H, COM3
> Port 2:E808H, IRQ: 09H, COM4
> Port 3:E810H, IRQ: 09H, COM1
> Port 4:E818H, IRQ: 09H, COM2
>
> TR PORT also looks correct - with COM1-COM4 mapped to E800, etc.
> TR IOPORT also seems to behave correctly at the E802, E80A,
> E812 and E81A addresses.
>
> Other, possibly relevant, information:
>
> - The DOS driver is from Oxford Semiconductors (it's called
> OXSER.EXE).
> - Running under FreeDOS, not MSDOS.
> - Same serial board works fine under Win XP with N1MM Logger.
> - I have a mult-port PCI parallel port installed with it's
> DOS driver - works fine with TRLog.
>
> 73,
> Steve, N2IC
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|