I got the Pigknob configured to 9600 baud (lowest it will go) but TR won't
exactly work with 9600. I can type in a freq in TR and the radio goes there
but TR just shows the correct 'band i.e. 40' but not the mode (shows a '?')
and shows the wrong frequency or no frequency. When I change the frequency
on the radio TR does not show the correct band but just the previous one.
This happens on both my radios a K3 and a IC-7800. Tree mentioned turning on
IRQ's in TR but I cannot find that option.
I have determined (assumed) that since I could communicate with the Pigknob
at 38400 that my serial cards are ok at 9600.
Any ideas-thanks,
Mike W9RE
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|