Scott, I just recently purchased a Paragon. I had called Scott at Ten
Tec before my purchase to inquire if it was possible to lower the output
on the Paragon. He rattled off the complete procedure, but I didn't
write it down since I didn't own one yet. So, if he can dictate it over
the phone, it must be factory authorized. I seem to remember him saying
the mod would take it down to 2 watts. BTW, mine goes down to about 23
watts right now, I'm planning on contacting Scott or the service dept.
soon to get the mod again.
Hope this helps.
73,
Eric
Scott Rosenfeld [NF3I] wrote:
>
> Have a Paragon.
>
> Min power output is about 10 watts (factory spec says 25).
>
> I NEED to go lower. Anyone know of a factory-authorized modification?
>
> * Scott Rosenfeld NF3I Burtonsville, MD FM19mc QRV 80-10/6/2/440 *
> * 6m 82 grids on 8w * DXCC WAS WAC * QRP-L #147 * QRP ARCI #9054 *
> * http://w3eax.umd.edu/~ham * ARRL Life Member /Laurel ARC/UMARA *
> *** 301-549-1022 h 301-982-1015 w *** 35 wpm HF mobile CW Neon ***
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
R. Eric Sluder, KB9BGS
Carmel, IN USA
kb9bgs@sprintmail.com
Professional Piddler
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|