I purchased a Ten Tec model 1208 20M-6M transverter in a
3/4-assembled state from the estate of a local ham. It's been working
perfectly here, but I am using my Argonaut for the driver, and would
like to free up that rig. I just recently picked up a "new-to-me" 2
Meter
multi-mode, and would like to use it to drive a transverter such as the
Model 1209 2M-6M transverter. This would give me the full band and
all-modes too...
I would like to do one of two things:
1 - A straight-up swap for my assembled 1208 for an assembled 1209
2 - A straight up swap for my assembled 1208 for a NIB un-assembled
1209
I am also open to offers/suggestions if reasonable. Drop me a line here
or over at the club's Email account at nq2rp@juno.com or call me on the
twisted pair. The home number is 716.494.1239 and the work number is
716.775.1803 There's a machine on line at home if I am not there...
72/73, Keith, WB2VUO, 100% QRP from the Great Bergen Swamp of WNY
"My night light runs more power than my Rig!!!"
_____________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com
Or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|