There is a card which supports the RS-232 interface. Take a look at the
back of the rig and see if you have a 25 pin D connector...
Communication with the rig is best described as 'wierd'. Not supported by
many programs but is supported by WriteLog.
-----Original Message-----
From: JEFF S JOHNSON <aa8ve@juno.com>
To: tentec@contesting.com <tentec@contesting.com>
To: <tentec@contesting.com>
Date: September 30, 1999 6:08 PM
Subject: [TenTec] rs 232
>
> On an Omni-V what is required to run a computer through the RS232 port?
>I hear about an interface or something but have never seen one and can't
>seem to find any info on them. Is that still required? what about
>software? I have a little 386 notebook just sitting here and would like
>to play around with this if I could.
>
>-Jeff- diddle de dar de dar
>___________________________________________________________________
>Get the Internet just the way you want it.
>Free software, free e-mail, and free Internet access for a month!
>Try Juno Web: http://dl.www.juno.com/dynoget/tagj.
>
>--
>FAQ on WWW: http://www.contesting.com/tentecfaq.htm
>Submissions: tentec@contesting.com
>Administrative requests: tentec-REQUEST@contesting.com
>Problems: owner-tentec@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|