My OMNI-D (SERIES B) receives on 30M but does not transmit. I was told a few
months back you need a board to get to to transmit on 30M. Yesterday I saw a
post where someone had stated that on some models of the OMNI-D all it takes
is a snip of a jumper to get it to transmit in that band (like the IC-730 for
example).
Is there any validity to the jumper wire fix? (SERIAL NO. 546-2356)
Alan KB7MBI
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|