Bill,
If you are handy with a soldering iron the fix is not so hard.
All that is required is to remove the PLL boards from the Paragon and
resolder the connections on the board, all of them. It seems more effective
if you remove the old solder before resoldering. I did the Remove before
resolder and have had no further problems with my Paragon.
Good luck with the problem.
>At 11:47 PM 5/22/00 -0400, you wrote:
To: <tentec@contesting.com>
>Date: Sun, 21 May 2000 22:28:42 -0700
>From: Bill Capps <wbcapps@mindspring.com>
>Subject: [TenTec] paragon:phase lock loop
>
>hello all
> what is done to cure the "phase lock loop" ailment in paragons.
> currrently
>my paragon goes into phase lock loop mode when i attempt to band change to
>160 or 80 meters.
> beginning to look like UPS trip to dolly parton blvd
Of course being in Alabama you are not for from Sevierville.
I would much recommend USPS over UPS. I have had several instances where
UPS has dropped equipment that was shipped with them. Most recently was
this last Christmas. I am still waiting on a settlement.
>73
>
>bill capps
>af4od
>auburn,alabama
Very 73,
George V73GT
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|