Hi All,
i have still not managed to solve the problem with my century22.
I have tried all the easy suggestions given such as bad connections, bad swr
etc but it is still showing this fault as described below.
> Hi All ,
> i am new to the list and wonder if any one can help with a fault
that has
> just developed on my Century 22.
> When i push the lock button to give a carrier to tune my atu etc,after
only
> a couple of seconds it drops out and then pulses slowly as if it were
being
> keyed.If i turn the drive down so there is only a couple of watts coming
out
> then it seems ok.If i turn it up to give anything over that it starts
> again.Any ideas most welcome,perhaps you have experienced this and know
> whats wrong and how to cure it ?
> Many thanks and i look forward to hearing from you.
>
Just wondered if any one else has any ideas or has come across this
fault before if you missed my earlier plea for help.
I have the circuit dia and operating manual,but not a service
manual,and my
friends
over here in England have told me that Ten Tec did not produce a service
manual for this rig.
Thanks for reading this and regards to all,i like this list interesting
to
read about all your
Ten Tec gear
Regards
Bill G4KKI
Member of RSARS,FISTS,RIG.
Website http:\\www.g4kki.freeserve.co.uk
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|