| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] OmniC |
| From: | geraldj@ames.net (Dr. Gerald N. Johnson, electrical engineer) |
| Date: | Sun, 31 Dec 2000 21:24:27 -0600 |
You might need to increase the preload on the main shaft by adding a washer in the back bearing. While you have the PTO out and apart, you might want to check ALL the solder connections in the PTO. 73, Jerry, K0CQ -- FAQ on WWW: http://www.contesting.com/FAQ/tentec Submissions: tentec@contesting.com Administrative requests: tentec-REQUEST@contesting.com Problems: owner-tentec@contesting.com |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Dead Omni VI+, K5XS@aol.com |
|---|---|
| Previous by Thread: | [TenTec] OmniC, Clark Savage Turner |
| Next by Thread: | [TenTec] test only, Graham Shortreed |
| Indexes: | [Date] [Thread] [Top] [All Lists] |