TenTec
[Top] [All Lists]

[TenTec] D-104 to TritonIV

To: <tentec@contesting.com>
Subject: [TenTec] D-104 to TritonIV
From: N4NT@chartertn.net (Mike Hyder)
Date: Wed, 9 May 2001 19:12:19 -0400
And if it is a crystal D-104 (maybe they all are) then it does not need to
have an amplifier in the base of the microphone.  Just straight wire the
microphone element to the cable and hook it up as Rich says below.

Mike

----- Original Message -----
From: "Richard B Drake" <rich@w3zj.com>
To: <tentec@contesting.com>
Sent: Wednesday, May 09, 2001 2:55 PM
Subject: RE: [TenTec] D-104 to TritonIV


>
>
> The Triton IV uses a 1/4 inch stereo plug for the mic connector.
> PTT to the tip, Mic to the ring (or band as Ten-Tec calls it),
> shield to the sleeve (or barrel as Ten-Tec calls it).
>
> ----
> 73, Rich - W3ZJ
>
> > -----Original Message-----
> > From: owner-tentec@contesting.com
> > [mailto:owner-tentec@contesting.com]On
> > Behalf Of Ed Howell
> > Sent: Wednesday, May 09, 2001 2:31 PM
> > To: tentec@contesting.com
> > Subject: [TenTec] D-104 to TritonIV
> >
> >
> >
> > Could someone on the list help me with the wiring to
> > connect a D-104 to a
> > TritonIV. I have searched all the places I can think of
> > on the net. Thank
> > you and 73....Ed



--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>