Hello OM's
I have the following problem with a Corsair II
I can get this tranceiver from a listener HAM, who never used this
rig for tranceiving.
Poweroutput in SSB is about 100 watts. (+/- 20 A on the meter of the
powersupplly)
In CW the output is about 12 watts max (+/- 8 A on the meter of the
powersupply)
I set the mode switch firs on LOCK, the ALC max clockwise and then turn the
DRIVER switch clockwise. The ALC led burns a very little.
The power meter shows bij max. driver setting about 12 watts..
Whwn I am going to CW mode everything is the same as in LOCK position.
I read the manual from front to the end....is this a technical problem, or
do I something wrong ??
Please reactions to PA3HGX@HOTMAIL.COM
73's from the Netherlands
Jos PA3HGX
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|