TenTec
[Top] [All Lists]

[TenTec] DSP Engine in New Rig?

To: <tentec@contesting.com>
Subject: [TenTec] DSP Engine in New Rig?
From: paulc@mediaone.net (Paul Christensen)
Date: Fri, 22 Jun 2001 10:24:53 -0400
> poor quality transmit CW note, and for my work here the transmit side tone
> is sitting in the middle of the receive audio output, way down in level
> (some bit below the noise) but my DSP system finds the tone and figures it
> has found a weak signal which causes no end of grief for my use of this
> family of products.

I just checked this on my Pegasus.  The CW sidetone is up at approximately
25% of full volume and is not affected by the DSP notch/NR function.  If
your sidetone is being affected by the DSP system, you may a have problem
with the transceiver.

-Paul, W9AC



--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>