TenTec
[Top] [All Lists]

[TenTec] Re: [Ten-Tec] keying circuit

To: <tentec@contesting.com>
Subject: [TenTec] Re: [Ten-Tec] keying circuit
From: kitdart@cfw.com (K Indart)
Date: Wed, 5 Sep 2001 21:40:15 -0400
I have not seen what the voltage rating is on the contacts of the TenTec
relay that actuates an older (tube) type amp such as the 30L-1, 30S-1,
SB-200, SB-220 etc.  I have not seen in the Manual that it is given, only
mentions "non Ten Tec amps"   The above amps use 115 VDC coils.   Just in
case I have built a small RS 12 VDC relay into a small black plastic RS
project box to key the amp.  The 12 VDC are taken from the rig 13.8 RCA jack
on the rear.  I have used this for years and never had trouble with pitted
contacts on the rig amp relay.
Ken  WA4RPH

-----Original Message-----
From: tentec-admin@contesting.com [mailto:tentec-admin@contesting.com]On
Behalf Of k4sqr@juno.com
Sent: Wednesday, September 05, 2001 5:59 PM
To: ku3g@yahoo.com
Cc: tentec@contesting.com
Subject: [TenTec] Re: [Ten-Tec] keying circuit


Sure John;

Run a shielded cable with RCA jacks on each end from the NO jack on the
Omni V to the Relay input of the amp. (Or chop off one RCA plug and add
what ever the amp requires.)

This was just asked yesterday, so I'll post to Ten-Tec as well.

GL,

Jim, K4SQR


On Wed, 5 Sep 2001 12:22:05 -0700 (PDT) no body <ku3g@yahoo.com> writes:
> does anone know of a circuit for an omniV to key a
> 30L1
> amplfier
> 73's john
>
> __________________________________________________
> Do You Yahoo!?
> Get email alerts & NEW webcam video instant messaging with Yahoo!
> Messenger
> http://im.yahoo.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>