TenTec
[Top] [All Lists]

[TenTec] Paragon less sensitivity on 12 and 10 meter

To: <tentec@contesting.com>
Subject: [TenTec] Paragon less sensitivity on 12 and 10 meter
From: Dan.Newby@cpspet.com (Dan.Newby@cpspet.com)
Date: Thu, 18 Apr 2002 11:02:14 -0400
Harry,

You might check the PIN diodes for those bands on the receiver's high pass
filter board. I have had to replace a couple of them before.

However, the most likely thing is the reed relays on the output low pass
filter board. The received signal goes thru it then on to the high pass
filter mentioned above.  Ten Tec had some problems like this with the
earlier Paragons and switched to a better reed relay. I had to replace
several of them on the Paragon I had. But as I remember, it has been a few
years ago, it wasn't too bad of a job.

Dan
WD4LUR



                                                                                
                                                       
                      DK2GZ@aol.com                                             
                                                       
                      Sent by:                 To:       
<tentec@contesting.com>                                                       
                      tentec-admin@cont        cc:                              
                                                       
                      esting.com               Subject:  [TenTec] Paragon less  
sensitivity on 12 and 10 meter                         
                                                                                
                                                       
                                                                                
                                                       
                      04/18/2002 04:26                                          
                                                       
                      AM                                                        
                                                       
                                                                                
                                                       
                                                                                
                                                       




Hallo

i noticed a much less sensitivity on 12 and 10 meter
on the Paragon.

All seemed o.k. up to 22 MC, but above there is much less sensitivity.


Any help?

73 de Harry, DK2GZ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec





<Prev in Thread] Current Thread [Next in Thread>