I have a Omni VI, upgraded to Option 3. With the power control at minimum,
the power on an uncalibrated meter seems to be around 5 - 10 watts. I'm
interested in running QRP. Is there a way to lower the power output? I know
of another Omni VI that does only put out a few hundred mW.
72/73,
Mark
----- Original Message -----
From: "Duane A Calvin" <ac5aa@juno.com>
To: <jlivingo@webtv.net>
Cc: <tentec@contesting.com>
Sent: Saturday, May 04, 2002 21:44 PM
Subject: Re: [TenTec] QRP WITH OMNI VI
> I can't tell about distortion, but on my 1997 vintage Omni VI+ (factory),
> running the power control at minimum produces 0.1 Watts out according to
> my Autek WM-1 power meter.
>
> 73, Duane
>
>
> On Thu, 2 May 2002 07:40:16 -0400 (EDT) jlivingo@webtv.net writes:
> > Dear QRP experts,
> > How low a power level can you take a "stock" OMNI VI and
> > operate
> > efficiently and without distortion? I have an OMNI V with a TEN
> > TEC
> > Factory QRP Mod which goes down to 1.5 watts.
> >
> > Thanks, Jim, K4CFA
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> Duane A. Calvin, AC5AA
> Austin, Texas
> ac5aa@juno.com -or- ac5aa@austin.rr.com
> Day: dacalvin@us.ibm.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|