TenTec
[Top] [All Lists]

[TenTec] Jupiter and remote?

To: <tentec@contesting.com>
Subject: [TenTec] Jupiter and remote?
From: timcook@erinet.com (NZ8J)
Date: Wed, 31 Jul 2002 22:41:56 -0400
Hi,

I recently picked up a used Jupiter and remote dial. The rig works flawlessly, 
but the remote seems to have a problem or else I am missing something.  I can 
enter frequencies from the remote, and I can program the function keys ok, but 
the knob will only change the freq by one "step" in either direction no matter 
how far I turn the knob or what direction. By one " step" I mean if I have it 
set to 10hz, the frequency will only change by 10 hz up or down, same for 10khz 
and so on. I am going to call Ten Tec tomorrow, but just thought I would throw 
this out here to see if by chance someone else had run across this.  The radio 
has ver 1.19 and has been updated to JT11KB (whatever that means).

one more question, with the mic gain control set at 0 I still get good alc 
action when using either a 705 or the Ten Tec hand mic.... any comments about 
this. guess I better read the archives before I ask too many questions...
Thanks 
Tim
NZ8J


<Prev in Thread] Current Thread [Next in Thread>